GATE

GATE NanoHARD AEG Mosfet Control Unit

Sold out
  • GATE NanoHARD AEG Mosfet Control Unit - Niagara Quartermaster

GATE

GATE NanoHARD AEG Mosfet Control Unit

Sold out

Click Above to Buy

Description

Features:

  • ON/OFF Active Braking , new generation SMART FUSE and Built-in Self Test
  • The NanoHARD is easily swappable between guns thanks to its built in deans style connectors, and resilient to withstand the most demanding setups. Designed for Li-Po's up to 14.8v
ON/OFF ACTIVE BRAKE
This is the first GATE controller that provides you with the possibility to turn off the Active Brake. You can enable or disable the Active Brake at any time.

SMART FUSE
The new AEG Controller should never let you down on the battle field. It is the best electronic fuse that has ever been made. This is the first AEG Controller with a true current sensor. A combination of current, voltage and temperature measurements provides your AEG installation with the high reliability. If your rifle becomes jammed, it protects motor and battery against any damage. There is no way to destroy the controller by overheating, overloading or short-circuiting of the electrical system.

BUILT-IN SELF-TEST
It allows you to quickly check whether the AEG Controller works properly. If you have problems with your AEG, the BUILT-IN SELF-TEST allows you to check that the problem is not caused by the controller.

MOSFET
Do you want to achieve a higher rate of fire and faster trigger response? Are you planning a power upgrade of your rifle? In that case, you need a MOSFET.
It targets the energy from the battery directly to the motor, bypassing the mechanical trigger contacts. As a result, you will gain higher rate of fire of the rifle and a faster trigger response, and the contacts will be protected against burn out.

Active Brake
Do you care about realism? Would you like to increase the life of the gearbox? Does your rifle have such high rate of fire that you are not able to make a single shot? Active brake will sort things out.
In SEMI Mode, the brake will not allow for compressing the piston after a shot. The piston will stop in front position which eliminates unnecessary stresses, increasing the service life of Gearbox and its parts. It is very important, especially with an AEG power upgrade.
After releasing the trigger, the rifle immediately stops shooting. Thus, you will gain more realism and, additionally, won’t lose your precious ammunition.

Protection against Over-Discharge of Battery
Modern LiPoly batteries are very sensitive to over-discharge. If you do not want to damage the battery and you care about its service life, this protection is indispensable. The microprocessor constantly monitors the battery voltage. When it drops down to a critical level, it will not permit firing.

Digital Interface / Debouncing
It provides full compatibility with micro-switches. It is fully resistant to contact bounce. You gain a bigger ROF, faster trigger response and your MOSFET becomes less heated.

3rd Gen. MOSFET
Usage of most modern transistors and micro-controller enabled us to create the smallest and most reliable MOSFET in the market. Tested with 14.8V Lipo battery

Coating
Thanks to its special coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C).

Included in the kit:
  • Additional kit of Deans-T Connectors
  • Single signal wire for trigger contacts
  • Double signal wire for trigger contacts
  • Programming Button
  • 2pcs Jumpers

12 Month Manufacturer's warranty against defect and craftsmanship
Professional installation is highly recommended
Warranty does not cover abuse or improper installation